How To Remove Sistaco Nail Polish

Answer

Verified

235k+ Views

To remove Sistaco nail polish, follow these steps: How To remove Sistaco nail powder using the Sistaco Express Remover? 1. Gently buff the surface of your colour to remove the Top Coat. 2. Apply the Express Remover taking care to avoid the skin. 3. Wait for 2 to 3 minutes or until the colour starts to lift. 4. Use the Sistaco 3-in-1 tool to push off the colour gently. 5. Take your time and be gentle. Repeat steps 2 - 3 if required but never apply Express Remover to the bare nail plate. Clean your nails afterwards and apply Sistaco Elxiir to nourish. How to remove Sistaco nail powder using Rapid Removal Hub? 1. Turn lid in an anti clockwise direction to remove. 2. Pour 5-40ml of 100% Acetone into the plastic insert provided and place into the ‘well’ of the hub. Replace the lid; fixing into position. 3. Using a nail file, gently file the Top Coat to break surface and remove gloss. 4. Turn on using the middle lower ON button. Small square lights will begin to flash, whilst your Rapid Remover heats. Once heated and ready for use the ‘Steam’ button will light up and you will hear a single beep. You can now insert your fingers into the top of the system as shown in your instruction booklet and grip the top slightly to allow the steam to better reach your nails. Be careful not to place fingers too low to avoid burning. 5. When the red indicator END light turns on, the steam process is completed by two beeps. Remove your fingers and gently push off your application using the Sistaco 3-in-1 nail tool. Do this immediately otherwise your nail application could harden again. If this happens you will need to repeat Step 4 again. After finishing wash your nails and use Sistaco Elixir to nourish.